Rainbird Master Valve Pump Wire Shorted Or High Current. Rain Bird Wiring Instructions Shorts will read between 0-8 ohms in most instances, although ganged valves will measure 1/2 the value of a working solenoid Ask a question, ask for help, show off your work (no advertising), or show us what some idiot did
Rainbird Wiring Diagram from diagramweb.net
If the short is in the field (wiring or solenoid) the station will operate without. It could also just be the wire is damaged overall though.
Rainbird Wiring Diagram
That will run the system normally and bypass the master valve If you do have a master valve or pump relay, this is from the troubleshooting section of the Rain Bird ESP manual: A short circuit in the solenoid or valve wiring has disabled the station You could open the master valve manually and then just disconnect the wire from the controller
The Ultimate Guide to Understanding Rainbird Irrigation Valve Diagrams. In order to repair it properly you can just replace the solenoid for the MV and you should be good to go What's my next step? Contractor's Assistant: I understand that you're experiencing an issue with your Rain Bird sprinkler system and receiving a message about a 'Master Valve wire shorted or high current.' Have you noticed any other problems with your sprinkler system?.
Rainbird Master Valve Wiring. See "Finding System Shorts" on page 11 for more information. Potential Causes: • Resistance caused by corrosion